Wireless Motion Alerts
are very popular units because they are easy to install and will
detect both vehicles and people walking. The radio operated drive
alert consists of 2 parts - a transmitter and a receiver with four
volume controlled tones. The receiver can be located in your house
and plugged into a standard wall outlet.
The weatherproof
outside transmitter will have an internal antennae to prevent it
from breaking off. ( Operating range: -30°F to 120°F .) , operated
by a 9 volt battery that normally lasts 6 months to 1 year, should
be located in the area of your driveway. The transmitter sends out
an invisible beam approximately 80 feet. The beam may be pointed in
any direction since there is no reflector needed at the end of the
beam. If a vehicle or person enters this area, the transmitter,
which detects motion will send a radio signal up to 3000’ back to
the receiver in the house.
To virtually eliminate the
possibility interference of a neighbors' driveway alarm interfering
there are 256 different security codes
Several Wireless Motion alerts
transmitters can be used with the same receiver. For example, you
may have 2 driveways entering your place. You can also have extra
receivers for additional locations such as a barn or shop.
Each receiver comes with choice of
volume controlled whistle, Westminster Chime, Ding Dong , or
Classical tone. The rubber hose drive alert will work with all our
optional driveway alarm accessories. Each receiver will have an
On/Off Switch , four form "C" relays and a timed output of 4 seconds
or 10 minutes for use with accessories.